This set of full replacement rails for your MN or ML will allow you to bolt in Falcon (Ba-Fgx) or Commodore (Ve) seats into your Triton. The seat height is only very slightly higher than factory level as can be seen in the pictures, but the extra comfort is well worth it!
As with our other kits, no cutting, drilling or welding is required. Since the rail kit included in this kit entirely replaces the falcon rails, any electrics inside the Ford/Holden seat rails will be removed so you will not need to wire that in. However, if you bought a seat with electric lumbar support or backrest adjustment you will need to run power to that.
While these seats will suit all MN and ML tritons, we do not recommend performing this conversion if you have a late model MN triton that has in-seat airbags.
Custom retrimmed seats shown in pictures are by Incharge Automotive Enhancements in Melbourne. Contact them here if you wish to order a set.
Please note - These kits have been designed to pass compliance laws in all Australian states. Legislation requires, however, that the installation must be sighted and signed off officially by a certified engineer in the state the car is registered. Until certified, these kits are intended for off road use only. Seats not included in sale.
These kits are shipped via courier and as such cannot be sent to PO Box addresses. Please only provide a residential or business address.